EpoxyFlooring (15 kg): self-smoothing floor coating & protection (yellow)

Two-component, self-smoothing epoxy resin for the protection and finishing of new and old floors.

Shrinkage-free, waterproof, applies over our PoxyFirst primer.

Good resistance to UV, wear, abrasion and acids...

Water jet washable

Colour : yellow

Read more
Reference RESFLOORJaune
En stock 3 Items
€159.03 (VAT incl.)

Quantity :

Make a request for this product


Main uses : industrial flooring, garages, exhibition hall, laboratory, housing...

Consumption for a self-smoothing coating : the application is made either with a notched squeegee 3x3x3 giving a thickness of 1 to 1.5 mm or with a squeegee 5x5x5 giving a thickness of 2 to 2.5 mm. 1.6 to 1.8 kg/m².

Consumption for a semi-smooth coating : spread the mixture with a notched squeegee at a rate of 1.6 to 1.7 kg/m², remove the bubbles then sprinkle the quartz over the surface.

After drying, trim and vacuum, then apply a sealing coat with a rubber squeegee. 0.5 to 0.7 kg/m². Uniform the whole with a polyester roller.

Consumption for a roller coating : apply 2 coats at a temperature of 20°C at a rate of 0.400 kg/m² per coat, respecting an interval of 16 hours between each coat.

Substrate preparation : Substrates must be dry, free of dust, grease, oil, moisture, curing agent, loose or crumbly parts and must not be subject to rising damp by capillary action. Possibility of using a PoxyFirst primer.

Stripping is done by mechanical action (sanding, planing, shot-peening, diamond sanding).

Preparation of the mixture : The components (Comp.A resin + Comp.B hardener) are delivered pre-dosed and should be mixed for 2.5 to 3 minutes at a speed of 400 rpm with an electric agitator fitted with a helical blade (right-handed pitch) with a diameter approximately 2.5 times smaller than the diameter of the seal.

Read more
Product Details

Data sheet

1.6 - 1.8 kg /m²
Open time
40 min
Use of the resin
No comments
Related products