Prerequisite: when handling products such as resin, it is recommended to take precautions. In order to avoid skin contact, it is advisable to wear suitable protective gloves (nitrile or butyl rubber with reinforced backs), face and eye protection (protective goggles), overalls, protective apron, knee pad and breathing protection mask.
Our resins are pre-dosed, so you get the right amount. Your kit includes resin, hardener, sand (0.2 or 0.3mm quartz) with rubber and basalt (anti-slip).
Caution! Our kit is not suitable for bakelized wood floors! You must make sure that your vehicle is level. During application, the temperature must be between 10°C and 25°C.
Strip the floor by the action of sandblasting, if you have existing holes you will have to fill them up beforehand.
Pour the hardener into the resin port and mix for 2 to 3 minutes. Empty the resin/hardener mixture into a large clean container and add the sand and rubber.
Step 3 :
Mark a surface of 2m² or 4m² depending on the kit chosen then apply your resin over the entire surface.
Step 4 :
Watch the setting, when the resin is still soft sprinkle the basalt for the anti-slip. Caution, watch that the anti-slip seals in the resin but does not run!
Indicative monitoring time: 30 minutes at 25°C in summer and about 1 to 1.5 hours depending on the temperature in winter.