POXYRIVER (10 kg) : epoxy coating and casting resin

Multi-purpose epoxy resin allowing the realization of river (casting resin) or the realization of stone carpet in interior.

Two-component epoxy resin used as indoor stone carpet or casting resin.

Continuous, non-shrink, waterproof coating.

Good resistance to wear and tear, acid abrasion, UV

Main uses: home, office, showroom, showroom, river table, pouring into objects

Use in casting resin :

Mix 3.5 parts resin and 1.5 parts hardener for 2.5 to 3 minutes at a speed of 400 rpm with an electric stirrer provided with a helical paddle with a diameter about 2.5 times smaller than the diameter of the seal.

Pour 1.5 to 2 cm of the mixture per layer.

Wait 4 to 6 hours between each layer at a temperature of 20°C.

Before casting, impregnate the wood with a brush.

When making, place on polyane or plywood board.

Theoretical density of the mixture: 1,11

Use in stone carpeting :

Mix the two components for 2.5 to 3 minutes at a speed of 400 rpm with an electric agitator equipped with a helical blade (right-hand pitch) with a diameter about 2.5 times smaller than the diameter of the seal.

Leave the mixture to stand for 10 minutes, the maturing time necessary to obtain a perfectly cross-linked, resistant and aesthetically pleasing coating.

After this time, a second, coarser mixing must be done to homogenize the whole.

For the coating of a semi-smooth coloured quartz 0.4/0.8 coating, the application is done with a rubber squeegee.

Consumption: 0.600 to 0.700 kg/m².

For a stone carpet, mix 6 to 8% of the mixture, calculated according to the weight of the aggregates (marble or coloured quartz 3 to 5mm). Mix the resin and the aggregates with a mixer powerful enough to homogenize everything. Spread the mixture evenly on the floor and then tighten and smooth with a trowel.

Consumption: 0.600 to 0.700 kg/m².